To
set the time:
A - Unscrew the crown (4)
B -When the watch second hand (6) is at
the 60 position pull out the crown stem to the 2nd click.
C - Turn the crown to the correct time.
NOTE: use the 24 hour indicator (7) as a guide to AM/PM
(0-12 = AM, 12-24 = PM).
D - When the time reference you are
using changes to 0, push the crown in.
E - Push the crown in and screw it down
to ensure water tightness.To set the date:
CAUTION: To avoid damaging the watch make sure
that date setting is done with the 24 hour indicator (7)
between 0 and 12 hours.
A - Unscrew the crown (4).
B - Pull out the crown stem to the 1st
click.
C - Turn the crown to the correct date.
D - Push the crown in and screw it down
to ensure water tightness.
To use the
Stopwatch:
A - Unscrew Pusher 1 (3) and Pusher 2 (5).
B - Press Pusher 1 (3) to start the
stopwatch. the Stopwatch Second Hand (2) will start to
move. as minutes accumulate the Stopwatch Minutes Hand
will move once for each minute.
C - Press Pusher 1 (3) to stop the
timing. The minutes and seconds can be read from the
dials.
D - To reset the stopwatch to Zero,
press Pusher 2 (5). NOTE: The stopwatch only times up to
60 minutes (shown on the Stopwatch Minutes Subdial). It
will stop after this time.
To zero the hands:
Only the Stopwatch Second Hand can be zeroed,
all other hands should automatically go to zero when
reset
A - Unscrew and pull out the crown to
the 2nd (time setting) position.
B - Unscrew Pusher 1 and press it to
move the second hand to the desired position. NOTE:
Continue holding down Pusher 1 to advance the hand
rapidly.
|
