| ********************************************************************** So, you got the balls to do a wheelie or stoppie, huh?! Trying to impress the ladies? well, man, it aint worth it, cuz you'll just end up wasting your bike and ... um...ya...you'll get hurt! which is not as important as the bike!!! But, i got the instructions here for you, so it's all up to you!! but man, becarefull, cuz it hurts!! Please, DO NOT try these stunts on the road!! If you did these stunts and got hurt, well, sorry man, i told you not to do it!! ********************************************************************** |
| How to do a Wheelie?!! |
| > First gear, pull away and let the clutch all the way out, then open the throttle fast enough and wide enough and the bike should pull away really quickly. If you are riding an R1,for example, it should start to do a wheelie at about 6-7000 RPM and it will literally jump up very fast so be careful not to let it go too high too quickly. It all deppends on the bike, the bigger the engine, the faster you can pop a wheelie. > The other way is kindda not good for your Clutch! what you should do is; start to roll in first gear, then pull the clutch in and give it a nice rev, then let the clutch go like a mad man, that should do it, you should get a nice kick and a nice wheelie, but basically you will ruin your clutch after a while. This method is used on the smaller engine (ie. Ex500)! > The guy in the pic is a pro, and he has combined a stunt move with a wheelei! so you don't try that, till you become a pro!!! |
 |
| How to do a Stoppie?!! |
| > Grab the front brake slowly at first and apply progressively more brake until the front end is fully loaded. Keep going further with the front brake lever in until the rear end comes up. Be ready to release your front brake as soon as you feel uncomfortable with how high the rear end is. Loading the front forks is important, because it transfers the forces from the bike's weight onto the front before you bring the rear up. You can't just get a stoppie by instantly applying full front brake! That'll just slide the front (even at 15 km/h if you pull too fast)!! Make sure you are really familiar with the bike, and make sure your speed is less than 15 km/h, cuz if you have a high speed, the front wheel will just skid, and Kaboom!!! There goes the bike!! |
 |
 |
| How to do a Burnout?!! |
| Uh man, why do you wanna do a Burnout?! why do you wanna waste your tire?! Well, i'll tell you why, cuz it's Freaking COOL, and you can make smilie faces on the asphalt!! .... But, seriously man, don't do it!! ... you wanna do it?! ... well, ok i'll tell you how!! > Hold the front brake all the way, pop it in 1st gear and hold the clutch in. While holding the front brake in, start to rev up ( you gotta use your palm, since you have like 2 fingers on the brake, so figure some way that is comfortabel for you, you know!). Slowly ease up the cluth and the back wheele will start to spin! To stop, just pull in the clutch and let go of the gas!! ... next step is to go buy a new tire! Hahahaha! told you!! |
 |
 |