Back to my Woodworking Projects Page.

Back to my Woodworking Page.

My Timberframe Cabin Page.

Back to my Homepage.

Soon after starting to do woodworking more sophisticated than pine bookshelves, I started making boxes mostly as presents for friends. Below I have posted some photos and short descriptions of some of them.

Early Boxes

This box is one of the first boxes I made. It gave me a chance to experiment with dovetails, and using handplanes to raise a panel (after a fashion). The lid surrounds a piece of glass that is meant to allow displaying lace behind it.

This box is one I made not too long after the first. It is of cherry with ebony detailing and inlays. I played around with laminating the pins of the dovetails with ebony so as to accent them. The finish is tung oil and wax.

A dovetailed box of walnut and ebony.

A Box For Jenny

Another box of walnut and ebony, though here the walnut is nicely curly. This box is probably my favorite, not because of the workmanship, but because of the wood. I was in a hurry to complete this in time for Christmas, so I used mitered corners rather than dovetails, adding ebony accent strips for decoration. The finish is tung oil, rubbed into the wood with fine wet or dry sandpaper for the first several coats. Then more with a soft cloth, and finally wax. This brings out the figure of the wood while filling the pores with sanding dust.

Later Boxes

This is another box, made using the same techniques as the walnut box above. I finished it pretty recently. The main wood used is curly cherry which I thought had some nice figure. The splines are ebony slices.

A Pure Handtool Experiment

This box was somewhat of a challenge because I decided I would use no power tools to complete it. It is made of some apple I had the good fortune to purchase several years back. The tree had been sliced into 5/4 inch slabs and I did all of the thicknessing of the wood using hand planes. Since the grain is rather wild with some knots this took a long time for me to finish. Then I raised the panel in the lid using a couple of old panel raisers, and cut some dovetails with a dovetail saw. This last step went less well than it usually does because I tried to make the box without being as careful as I sometimes am to get everything uniform. If you measure old dovetails you will sometimes find that the skilled craftspeople who made them measured by eye and yet you don't see it except in very subtle ways. I erred a bit on the sloppy side, however, and had some trouble marking the pins from the tails since the sides were not of uniform thickness. Still with a bit of patching it looks alright. After gluing it up, I cut it open with a handsaw filed rip, and planed the edges smooth. Tung oil and wax finish the box.

This is another box I made recently out of cherry with ebony trim.

This is a box I made for storing crochet needles. It has a sliding lid of ebony on a cherry box with cherry details.

Another wedding box with a bookmatched claro walnut lid, black walnut sides, and ebony trim. The claro on the lid was wild enough that blackened epoxy was used to fill holes in the wood.

Not Exactly A Box

This box is actually a cabinet for an old set of mono preamps I got many years ago. The box itself is made of plywood, veneered with curly koa veneer and detailed with ebony and ebonized maple. Since I had not worked with veneered plywood before I got some help from my friend Rich Christie who is a far better woodworker than I.