Follow the steps below and use the pictures available for an accurate idea as to how to go about doing this.

1. Find the ABS "Y" and the second length of 1.1/2" ABS pipe (this piece should only be about 2" long...very short!!) Glue this extremely short piece into the "downward" hole of the "Y".
   

   
   

2. Grab the 45o elbow and glue that onto the other end of the short ABS piece. **Note**: Be VERY careful to make sure that this elbow lines up straight with the rest of your barrel!!!
   

   
   

3. Find the first length of 1.1/2" ABS pipe and glue that into the open end of the elbow (this length of pipe should only be about 4-5" long, do not make it too long.)
   

   
   

4. Glue the 1.1/2" pipe connector to the end of the 1.1/2" ABS pipe inwhich you just recently glued.
   

   
   

5. Now for the final step...glue the 1.1/2" threaded male adaptor into the 1.1/2" pipe connector. There you have it, this hunk 'a junk is all done.
   

Ok, now yer wonderin "How the hell does this thing fit on mah cannon???" Well that's why I'm here to tell yah, stupid. This process involves a bit of cuttin, so yah might wanna watch yer fingers, heh heh heh.

HOW TO ATTACH THIS THING TO YER GUN is really quite easy. The only thing you do is measure about 3/4 -1" out from the 1.1/2" reducer of yer cannon. (see the picture below if this doesn't make sense.)

Then all yah gots to do is glue the safety attachment into the hole yah just created, glueing the rest of the barrel into the far end of the attachment...here look at the diagram.

Ok, that's all folks!!!

Main Page | Tips

This page hosted by Get your own Free Home Page