ANYONE WILLING TO ENGAGE IN THE FOLLOWING ACTS HAS MY PERMISSION TO NOT AFFIELATE ANY ACT DONE WITH THIS PAGE!

How to make easy home made Bongs

a bong is an easy thing to make all you need is :
1:a plastic bottle (gatorades the best)
2:some electrical tape
3:a socket(check the tool box)
4:a tube big enough for the socket to fit into firmly
5:a peice of screen (look at your doors and windows)
6:water
7:herbs

Ok 1st make a small incision in the bottle near the bottom (not at the bottom but up on the side , you need room for the water).Then you must fit the socket into the piece of tube and make sure the socket will fit!Followed by pushing the tube into the small incision (it has to be tight so no air can escape)if it wont stay air tight (I highly suggest this)wrap some electric tape around the end of the tube (where it meets the socket)and jam it in there tight.Then you must cut a peice of screen and fit it into the bowl (end of the socket).Then puncture a small hole opposing the bowl (the other side of the bottle)about the size of your pinky finger . then finally place some water into the bong (just below the hole below the tube).Check the bong by placing your thumb over the hole in the back(carborator) and putting your mouth over the mouth piece and suck in, if it bubbles it works , if it bubbles and you release the carborator andit stops bubbling it works , if it dosent bubble it dosent work , and if it bubbles when you release the carb its fine and will work.LAST place the herb into the socket over the screen light a candel , light a lighter , place the lighter up to the herb (while covering the carborator) and inhale.

If you run into any problems e-mail me at

Back